cTi B-R-Piep

Operating instructions for switching module B-R - PIEP
 
Switch module for brake light and reversing light and reversing beeper.

The B-R-PIEP is looped into the receiver line to the travel controller.
It therefore operates parallel to the travel controller and therefore no further channel is necessary.
A Y-cable is also not necessary, there is a 3-pin pin on the B-R-PIEP.
The brake light is now controlled at a standstill, but only for a maximum of 8 seconds.
If the joystick is now deflected forward or backward, the brake light goes out.
When the joystick is moved back to the center, the brake light goes back on, and off again about 8 seconds later
 
When reversing, the backlight is lit.
In addition to the light, the built-in beeper sounds with a beep interval of approximately 0.7 seconds.
Special highlight, the 2-wire connection!
Only a thin two-wire strand is required to connect the 4 LEDs.
The diode function of the LEDs is used to distinguish the lighting control between the brake light and the reversing light.
The LEDs have to be connected "only" correctly to this two-wire braid.
This saves a lot of cable.
 
It is also not necessary to distinguish between red and white LEDs,
and there is also no need for a series resistor for the LEDs.
The current is limited to the B-R-PIEP.