Top seller
No results were found for the filter!
Product number: 33474
Completely assembled 3-side tipping bridge with hydraulics. The tipping bridge is designed for 3-axle vehicles and comes ready assembled. A subframe for mounting on the vehicle is also included. The tipping bridge can be unlocked by...
1,095.00€ *
Delivery time: will be ordered / produced for you
-5.91%
Product number: 33359
Rear underride protection suitable for TAMIYA rear tipper (30056357). The scope of delivery includes modified end crossbeam for holding the towing jaw (500907182), this is required as soon as an elevated kit is used. Thus, clutch level...
50.80€ * 53.99€ * Manufacturer's RRP
Delivery time: Ready to ship, appr. 2-5 workdays **
-20.68%
Product number: 33358
Lifting kit suitable for the TAMIYA rear tipper and all 3-axle Euro tractors. This set is suitable for the axles included in the kit as well as the Carson drive concept (self-locking axles). The vehicle is set visually higher, a greater...
34.10€ * 42.99€ * Manufacturer's RRP
Delivery time: will be ordered / produced for you
Product number: 70224
Spindle drive suitable for Sandmaster 370 included subframe Aluminum parts, screwed Trapezoidal spindle, rear mount with ball bearing 7.2V engine with gearbox with subframe We recommend to operate the mini cruise control MFR or MFX...
273.00€ *
Delivery time: will be ordered / produced for you
Product number: 41049
we offer a fifth wheel with mounting parts and control lever. In the bottom part is a hole prepared for the infrared diode. This fifth is the current one from Tamiya.
49.50€ *
Delivery time: Ready to ship, appr. 2-5 workdays **
Product number: 41038
Fixed mount for Tamiya fifth wheel directly on the frames.
12.50€ *
Delivery time: Ready to ship, appr. 2-5 workdays **
Product number: 41014
This kingpin is designed ecspecially for 1-axle dollies. It works with less fixture.
6.50€ *
Delivery time: Ready to ship, appr. 2-5 workdays **
Product number: 41026
This Shortwood container is designed for Leimbach roll-off-tippers. It is prepared to be mounted on the Leimbach carriage for the tipper. Also the holes for the fastening of the rolls 39607 are prepared. Specification: length: 394mm...
245.00€ *
Delivery time: will be ordered / produced for you
Product number: 41021
´This supporting feet can be used for Leimbach supports instead of the original ones. This way you can support on sloping surfaces. The support feet can easily changed against the standard one. Content: 1 foot
5.25€ *
Delivery time: Ready to ship, appr. 2-5 workdays **
Product number: 41025
This racks can be mounted with an additional frame on a Tamiya truck frame. This way you can convert your truck easily to a wood transport. The sam can be done with trailers in Tamiya size. Additional frames can be build out of 31420 and...
35.99€ *
Delivery time: will be ordered / produced for you
Product number: 39792
New roll-off container with increased front and rear parts. This increasement shall ensure, that the cargo does not fall over the edge of the hollow. width: 182mm length: 420mm height: 123mm
252.00€ *
Delivery time: Ready to ship, appr. 2-5 workdays **
Product number: 39793
upgrade kit for low roll-off containers with 2 steps. With this kit you can upgrade your existing container to a new style one.
97.50€ *
Delivery time: Ready to ship, appr. 2-5 workdays **
Viewed